SerialAPI: Command: 0xa4 is not supported by this SerialAPI
Re: SerialAPI: Command: 0xa4 is not supported by this SerialAPI
Can we have remote access to it? Please send it in PM
-
- Posts: 1
- Joined: 06 Oct 2018 17:50
Re: SerialAPI: Command: 0xa4 is not supported by this SerialAPI
newuser wrote: ↑05 Sep 2018 09:56Hello!
I'm using Z-Wave.Me UZB as a bridge controller for Z/IP Gateway. It works fine until I start to communicate with devices. Every time when I send commands I get the next errors in zipgateway.log.
I tried to find out the problem in the source code of Z/IP Gateway and did not find the answer.Code: Select all
SerialAPI: Command: 0xa5 is not supported by this SerialAPI SerialAPI: Assertion failed at /var/lib/jenkins/jobs/Full_S2_Gateway_release/workspace/src/serialapi/Serialapi.c:600 SerialAPI: SendFrameWithResponse() returning failure 33324 virtual_nodeid_init_count: 0 33341 Creating virtual node SerialAPI: Command: 0xa4 is not supported by this SerialAPI SerialAPI: Assertion failed at /var/lib/jenkins/jobs/Full_S2_Gateway_release/workspace/src/serialapi/Serialapi.c:600 SerialAPI: SendFrameWithResponse() returning failure 33341 create failed, will retry 34341 Creating virtual node SerialAPI: Command: 0xa4 is not supported by this SerialAPI SerialAPI: Assertion failed at /var/lib/jenkins/jobs/Full_S2_Gateway_release/workspace/src/serialapi/Serialapi.c:600 SerialAPI: SendFrameWithResponse() returning failure 34341 create failed, will retry
This problem is also described on Z-Wave Public Forum.
Thank you
Thanks for the link.