How to upgrade the firmware?

Discussions about RaZberry - Z-Wave board for Raspberry computer
Post Reply
tab8
Posts: 2
Joined: 18 Jun 2020 15:15

How to upgrade the firmware?

Post by tab8 »

Hi.

Sorry, a total newbie here...

Code: Select all

Vendor:	RaZberry by Z-Wave.Me
Vendors Product ID:	1024 / 1
Z-Wave Chip:	ZW0500
I've installed the razberry image to a Pi 2 Model B+ and updated everything via

Code: Select all

apt update & apt full-upgrade
I went to: http://192.168.0.104:8083/expert/#/uzb

and see these entries:

Code: Select all

2015-01-01	5.0			Update bootloader from default for 5.00 to 538d	
2015-09-15	5.0		5.4	Update firmware from 5.00 to 5.04	
2015-09-18	5.0		5.3	Update firmware from 5.00 to 5.03
and if I use the "Upgrade bootloader" button it communicates with the device (a few seconds later the green and the red led flash up for a second) but when I go to the page again I still see the same entries.

Another thing:

Code: Select all

./ZMESerialUpdater serialapi_uzbupdate -d /dev/ttyAMA0
does not work. The tool does never show anything else than new -> lines every few seconds (the device /dev/ttyAMA0 is correct).

How do I upgrade this thing to the latest available bootloader + firmware?

User avatar
PoltoS
Posts: 5631
Joined: 26 Jan 2011 19:36

Re: How to upgrade the firmware?

Post by PoltoS »

For 5.0 after the bootloader upgrade still shows same. So check the log that boorloader succeed and then do firmware upgrade to 5.4

tab8
Posts: 2
Joined: 18 Jun 2020 15:15

Re: How to upgrade the firmware?

Post by tab8 »

Thanks, that worked. Now the firmware upgrade page doesn't list any more updates (neither bootloader, nor firmware).

User avatar
PoltoS
Posts: 5631
Joined: 26 Jan 2011 19:36

Re: How to upgrade the firmware?

Post by PoltoS »

enter "all"

Post Reply