forum

<t>I have been using a HomePro ZRP230 switch module for a couple of months now and suddenly it got broken for no special reason. I received a replacement module, which is working fine (I can switch it on/off with the button on the module itself). However, when trying to add this new module to my Z-W...

<t>In fact I tried this before (just to be sure the inclusion would work) and just tried once again excluding it first and including it afterwards, but no result so far...<br/> <br/> I checked the job queue while including the device and noticed that it said "Node found: node 0" and then "Failed" af...

Hardware
Vendor: Z-Wave.Me
Vendors Product ID: 1 / 1
Z-Wave Chip: ZW0301

Firmware
Library Type: Static Controller
SDK Version: 5.03
Serial API Version: 03.55

<r>Unfortunately, I don't have any portable controller (only the Z-Wave.Me-stick attached to my OpenWRT-router) <E>:-(</E><br/> <br/> I still don't understand why I could include this device a couple of months ago, while it fails now for the replacement module. Well, I guess I'll have to buy a porta...

<r>Thanks for the suggestions, I have tried both single and triple-clicks which might explain the confusing error messages. According to the documentation (<URL url="http://www.act-remote.com/HPW/Inst/ZRP230_instr.pdf">http://www.act-remote.com/HPW/Inst/ZRP230_instr.pdf</URL>), a single click should...

For the record, I bought the Aeon Labs Minimote remote and was able to exclude the device with this remote. Afterwards, including the device in Z-Way was no problem at all!

<t>I tried compiling Z-connector and the Makefile seems to contain an error. The following line:<br/> $(INSTALL_BIN) $(PKG_BUILD_DIR)/z-connector $(1)/bin/<br/> <br/> should be changed to:<br/> $(INSTALL_BIN) $(PKG_BUILD_DIR)/z-agent $(1)/bin/<br/> <br/> I also had to select the option "[*] Build th...

<r>I attached a Z-Wave USB-stick and compiled the latest version of the z-connector (1.02) for DD-WRT, but I'm unable to set up a reliable connection to the zwave.me-server. This is the debug-output of z-agent:<br/> <br/> <I><s>[I]</s> Opening device...<br/> [D] Configuring device...<br/> [D] Creati...

<t>I recompiled the last version from source and still get the same error. I used following command to run the z-agent on DD-WRT:<br/> /mnt/bin/z-agent -s z-cloud.z-wave.me --cacert /mnt/etc/certs/cacert.pem --cert /mnt/etc/certs/cert.pem --key /mnt/etc/certs/cert.key -d /dev/tty<br/> <br/> Meanwhil...

<t>Apparently the required kernel module was not yet properly loaded (I did not notice this earlier). Once I loaded it, a device file /dev/ttyUSB0 was created and now z-agent runs fine. Note I switched to OpenWRT in the mean time as my DD-WRT-installation was a bit outdated. Thanks for the detailed ...