forum

thanks,

I replace file but it is still visible in elements..
what could I do now with it ?

I've tested GroupDevices APP and now I have four times GroupDevice_20 in elements section...
I can't remove it via GUI... is there any chance to remove it from system - without erasing zway to factory default ?

thanks for fast reply tell me what with ground ? cause shield is the ground ? for example I could take pigtail with SMA from home router/ap and make antenna SMA interface for SMA connector with 85mm wire ;) but the pigtail has signal cable in the middle and ground/shield.. where did you connect it ?

but after 15cm shielded cable You added 8,5cm wire - it has to be exactly 8,5cm ?? and length of this 15cm cable it doesn't matter because it is shielded ?? only I have to be careful with 8,5cm wire (antenna) ???? Maybe I could use antenna like this: http://p.globalsources.com/IMAGES/PDT/B1025266046...

I've updated razberry to 2.1.1. and it works :) At Scene I can't set dimmer 0 but in LogicalRule - it works now perfectly you can set the action of dimmer to 0 and it fade out and switch off then ;) for light fade in and switch on - I made Http device and use web API to switch the light on - and the...

what kind of cable did you use ?
and it has to be exactly 86mm lenght ?

after years - how it works now? still ok ?

I bought another dimmer (the same model) and with this I have the same problems with range... I don't know is this normal or I have some problem with raspberry z-wave module ?
or maybe whole part of dimmers from this seller are broken ?

what is your range of z-wave raspberry module ?

it's official or beta?

Version number: v2.0.1

yes and I have problem with this last rule - when motion detector goes innactive - the logicalRule could only make action like "dimmer set to 1" - not off or to 0 ;(
and dimmer show still that is On ...