forum

Hallo,

Is it possible to send the battery status from the device to the controller when a FLiRS device gets active?

Hallo,

I have added a "void setSensorMode(sensor_mode mode);" function to the library to set the chip in the given power mode. Is it possible to integrate this function in the library? What do I have to do with the patch?

This is works fine in 2.1.5 update. Try to exclude your zuno and then include. If it won't work try other zuno. Also wake_up command class can be only in always sleeping device. Nowit works fine. But first i had to perform a "Erase NVM: All" once during one upload. It seems like the Devic...

Hallo, I would like to implement an FLiRS Device with new 2.1.5 release and the dynamic channel asignement. I havethe following code: #include <ZUNO_BMP280.h> #include "Wire.h" ZUNO_SETUP_SLEEPING_MODE(ZUNO_SLEEPING_MODE_FREQUENTLY_AWAKE); ZUNO_ENABLE(LOGGING_EVENTS LOGGING_UART=Serial WIT...

Hi all, I have great problems with the new release and old software. Could you kindly send me an an example of a sensor multilevel device with 3 channels? I was using the following code in order to setup the 3 channels: ZUNO_SETUP_CHANNELS( ZUNO_SENSOR_MULTILEVEL( ZUNO_SENSOR_MULTILEVEL_TYPE_GENERA...

I have a problem with the ZUNO_SETUP_SLEEPING_MODE(ZUNO_SLEEPING_MODE_FREQUENTLY_AWAKE); with the loop I call zunoSetBeamCountWU(10); zunoSendDeviceToSleep(); but the device does not wake up any more. The Battery and wake_up command class is also missing on the contoller side. But in react on any co...

The same problem observed. When USB_DM is pulled up to +3.3V (after the programming!) by 10kOhm resistor the sketch works properly. That is what I did as well now. Do you have anSUB connector on your module? Or just headers? I have the suspicion that the chip does something strange. You can observe...

Thank you for your answer.

Does

We have fixed this. Please reinstall the cores.

mean one should reinstall the core via the arduino ide?

New channel mapping to channel 0 If the channel appears only once, it will not be inside MultiChannel, but rather on the root (channel 0) device only. Additional channels are not created anymore for that case. Is it possible to get the old behaviour backagain? I would like get the Status of the ind...

Ok I have a few more information about my problem: 1) the z-uno module is really alive and just trappen in something. I implemented a counteron the serial port and it just stops counting when I plug of the USB cable and continous counting when the cable ispluged in again. 2) WhenI plug off the USB c...