forum

My Aeotech Multisensor 6 in 1 gives sensor results, which are way off the real value. Therefore I am trying to calibrate the sensor by setting the paramater 201, 202 and 203. For 204 I do not have a reference. I got to manage the calibration of the temperature. The temperatur read was 4.5 degrees hi...

After I had updated the z-way software to version 2.3.0 the inclusion and the interview finished without any problems and even the hardware configuration is theoretical possible. But there I have some problems and I have opened another post. It seems to me the older software was not fully supporting...

For me it seems that your devices are not in range. Did you change something in your building or may 1 device is broken and does not repeat? First look if the led on the daughter card is on. After try to bring the Razberry very close to a device and try to switch this device.

In the mean time I have updated the Razberry firmware to 2.3.0. After I got another freez of the motion sensor. But this time the sensor did not report even the lumination values. At the end I could not even wake the device by pressing the button. After I measured the battery and it was showing 0.23...

theoretically yes. But I am having problem with the sensor. After some days it freeze and motion detection is not possible as the interview cannot be completed.

Still getting the problem after using the ExpertUI and returning to the Razberry main menue. The device I have worked on is lost.

After I found continuing issues with the Fibaro motion sensor I bought an Aeon Multisensor z-waves Plus. The inclusion has the same problem like the Fibaro devises. I am getting max. 86% interview completed. The sensor shows values but exept the lumination sensor all others are way off the real valu...

After several attemps I am having a long queue waiting to be sent. But I am in network range! This is a multisensor and I am getting the results of the lumination sensor in the device without problems. Let me ask you again. Do you have the firmware version 3.2 on the sensor? Do you have the razberry...

If I try to change the settings in expert mode the same problem occurs. If I am opening the expert mode even just for monitoring I am losing the temperature sensor. Only the lumination sensor remains.

I know about the possibilities of settings an I want to set it up my way. But it does not allow me to save the changed data. The device should be awake as I am continiuosly pressing the button on the device.