forum

I found myself a solution for point 2 by replacing "valveValue == HIGH" by "valveValue > 0" here: //Valve is opened if moisture <20% and tank is not empty, or forced from Jeedom if ((valueMoisture < 20 && currentLevelState == LOW) || valveValue > 0) { digitalWrite(pinValv...

Hi all, Here is my code for a watering system that includes: - a moisture sensor - a valve - a water tank with a level sensor #include "Wire.h" #define pinValve 19 #define pinMoisture 4 // Moisture sensor on ADC1 #define pinLevel 12 // Water tank sensor (0 when full) byte valveValue; byte ...

Update: I also added a dummy moisture sensor, now I see all my sensors ... including the 2 dummy sensors ! That finally makes a not very clean code but it does the job. I hope it will help those who uses Jeedom domotics system, and that this behaviour with Jeedom will be fixed with the future Z-Uno...

Thank you PoltoS ! A little improvement ... but also a regression :( After having added a dummy Voltage Sensor in my code, I can see both of them (49/1/15 and 49/2/15), but only 2 of the 3 moisture sensors (49/3/31 and 49/4/31). Here is my code: ZUNO_SETUP_CHANNELS( ZUNO_SWITCH_BINARY(getterVanne1, ...

I tried to come back to 2.1.6 (Board manager of Arduino IDE + Burned bootloader), same issue ... I'm desperate, this bug is blocking me in my project. Please help me ! My bug report: Z-Uno bootloader version: 2.1.6 or 2.1.7 Security: none Frequency: EU Device included: yes Device included securely b...

Hi all, I'm facing a strange behaviour with my Z-Uno: I have different types of switches/sensors in my project. If at the ZUNO_SETUP_CHANNELS level, I declare : ZUNO_SENSOR_MULTILEVEL(ZUNO_SENSOR_MULTILEVEL_TYPE_VOLTAGE, SENSOR_MULTILEVEL_SCALE_VOLT, SENSOR_MULTILEVEL_SIZE_FOUR_BYTES, SENSOR_MULTILE...

Ok thanks
Just one last question: do you confirm the SMD size of 0402 ?

Thank you PoltoS.
Very low value for a capacitor. Is it a coupling capacitor between the antenna and the rest of the RF circuit ?
Can I replace it by just a short circuit ? Because it's very very tiny and it would be hard to solder an new one in place.

Hi all,
Is there a full electronic diagram of the Z-Uno available somewhere ?
I'm trying to find the value of C13 which is the very small SMD capacitor close to the antenna.
I unfortunately removed it accidentely while desoldering the antenna and I lost it.
Thanks !

Does version 2.1.7 work for you in Arduino IDE 1.8.13? I get compiler errors like Stream_sdcpp_.cpp:16:26:error:unknown type name 'uint32_t' I'm also waiting since november for the release notes of 2.1.7. I didn't notice any issue with 2.1.7 + IDE 1.8.13 except with the FLIRS mode that seems to not...