I sent an email at 26.8. but did not get a response since.
Could you check the status of my request?
Search found 6 matches
- 09 Sep 2022 10:32
- Forum: Z-Uno
- Topic: Syncing with Z-Uno always failed when burn boot loader
- Replies: 16
- Views: 28207
- 25 Aug 2022 17:12
- Forum: Z-Uno
- Topic: Syncing with Z-Uno always failed when burn boot loader
- Replies: 16
- Views: 28207
Re: Syncing with Z-Uno always failed when burn boot loader
Hello! Looks like a h/w issue. In which country are you located and where you bought? We can swap it with a new one and take this for experiments. I am located in Austria and bought it here (Poland): https://botland.store/z-wave-executive-modules/9042-z-uno-2-plate-is-z-wave-compatible-with-arduino...
- 24 Aug 2022 18:32
- Forum: Z-Uno
- Topic: Syncing with Z-Uno always failed when burn boot loader
- Replies: 16
- Views: 28207
Re: Syncing with Z-Uno always failed when burn boot loader
Sometimes the Z-Uno blinks the green LED, but it is very irregular and the board does hardly ever accept sketch/bootloader updates. It seems as if the Z-Uno is quite busy with itself, as it shows the same behaviour with bare minimum sketches as well (one can upload them with much patience and a huge...
- 23 Aug 2022 07:11
- Forum: Z-Uno
- Topic: EEPROM example code not working properly
- Replies: 10
- Views: 3857
Re: EEPROM example code not working properly
Never don't touch a not-running system
- 22 Aug 2022 17:35
- Forum: Z-Uno
- Topic: EEPROM example code not working properly
- Replies: 10
- Views: 3857
Re: EEPROM example code not working properly
It would be really helpful to mention this serious EEPROM issue here: https://z-uno.z-wave.me/arduino-install/ I spent a whole day trying to get config channels to work - always got completely wrong values from the EEPROM. With 3.0.9 everything now works like a charm - this information could have sa...
- 22 Aug 2022 17:18
- Forum: Z-Uno
- Topic: Syncing with Z-Uno always failed when burn boot loader
- Replies: 16
- Views: 28207
Re: Syncing with Z-Uno always failed when burn boot loader
Facing the same issue now. Z-Uno 3.0.9 Sketch was running for a few days without problems - today the node was gone and the device did not show any LEDs anymore. Left it sitting without power for a few hours and was able to get serial messages after that. Tried uploading a slightly modified sketch -...