Can't get any associations to work

Discussions about Z-Way software and Z-Wave technology in general
Post Reply
egregor
Posts: 1
Joined: 20 Mar 2016 03:59

Can't get any associations to work

Post by egregor »

Hello,

I'm new to Razberry. I recently purchased an Enerwave Scene Controller and a light switch to go with it. I'd like to set up the controller to turn on the switch when one of the 7 buttons is activated. I cannot figure out how to do this using the expert UI.

Thus far, I've tried adding the switch to association group(s) in the controller configuration, and vice-versa. So far, all I see is adding a device, with no additional options for configuration (see: http://imgur.com/MaJlyuF )

I feel like I'm missing some step here after a device is added to the group, but can't figure out what it is!
Post Reply