VS Plugin Issue

Discussions about Z-Way software and Z-Wave technology in general
Post Reply
jrossouw
Posts: 16
Joined: 22 Sep 2020 12:38

VS Plugin Issue

Post by jrossouw »

Hi,

I am a Mac user. After initially installing the VS plugin I managed to compile code successfully and upload it to the Z-Uno Gen 2 and everything worked as expected. However, the next day when I restarted VS the plugin initialised ok, but when I try to run any of the plugin command (verify, set frequency, set board etc.) I get the following type of error:

Command 'Z-Uno: Verify' resulted in an error (Cannot read property 'core' of undefined)

Is there any way on the Mac to run the commands from the command line?

Thanks,
Johan
Post Reply