Automation UI issue

[Mike Yeager]

I'm using v2.2.2 and I'm noticing that the interface isn't accurately reflecting the condition of my door locks. The events aren't showing up in the event log either. When the lock is activated by hand, there should be an event but there isn't. They're Kwikset locks and they've always seemed to work before. If I go into the expert interface and update the device from the control page, it changes it to the current state. Is this possible caused by an incorrect device description? There's 3 or 4 entries for these locks...

[Mike Yeager]

I found the user module Niffler that was written to deal with several devices (including locks) that don't update as expected out of the box. I'll let you know if I have any further issues...