Hi,
this will not work as you expectred, I think so...
Domoticz is using OpenZwave - Z-Way is another certified software product.
The "only common" detail is, that for both products for the Z-Way network are using the Z-Wave chip (in your case the Razberry controller) and storing all the
network information in the Z-Wave controller (Razberry).
The network information is (simple to say) the Home-ID (network-ID), any security information, the Node-ID and the main device IDs.
All additional information will be stored in OpenZwave in the config files (ozwcache_0xABCDEFGHI.xml) and in domoticz.db
So you can of course check your devices and controller in Z-Way, it should work, all devices must be available here too - after call NIF, force interview or wake-up the battery devices.
Maybe you must move devices near controller - depends on device...
But same you could do in Domoticz.
If controller will be recognized there - configured as AMA0, and you see after enable the OpenZwave version - you should see the list of Z-Wave devices there in setup. A simple move of controller from one software to other will not work (only network itself with main information can be restored).
The actual Domoticz version 2020.1 and 2020.2 have Z-Wave problems, as you can see in Domoticz forum - so I would not suggest to use the new version just now, if you are not an expert.
So you could decide - use in future Z-Way if you like the UI and the included features, or return to Domoticz.
In second case would suggest to ask in their forum about the problems, there you will get the right (and more) information.
If you will like Z-Way - you are welcome here of course
In this case I would suggest to
close this topic (Domoticz related) and search in forum for your problem, read documentation - and ask in this forum about your Z-Way problems with the right Subject - then you can get soon help
I use Domoticz since 2014 - and Z-Way since 2013 ...
Best regards
Michael