forum

I have a freshly installed Z-Way on a Raspberry Pi 4 with a Razberry 2 module. The module is detected, but it is not possible to pair a Z-Wave actuator. The operation times out each time. In expert mode it shows some kind of reaction when inclusion mode is started at the actuator, but also here the paring just stops without any effect. The installed Razberry 2 firmware is shown as 0.0.

My guess was, that a firmware update could help. However, I am not able to find any firmware file all all. How to proceed?

Thanks a lot!

Version 0.0 looks very strange. Please provide the log.