Hi there,
I am new to all this and have just purchased a raspberry pi and razberry conrtoller board. I installed the standard image from http://razberry.z-wave.me (done it several times and flashed several cards - even tried a different raspberry pi). First I purchased some qubino relays - they just wont pair - next i bought some Vision sensors and they too wont pair. It just says inclusion takes a long time to start and does nothing. I tried to contact intuitech (the supplier) in case there is a problem with the board itself but have not gotten a response. Does anyone have any insight that might help me?
Thanks in advance.
Cannot pair anything on new setup
Re: Cannot pair anything on new setup
Make sure the frequency is same (change frequnecy in the Expert UI -> Netwrok -> Control).
Try to exclude first.
Make sure to correctly initiate learn mode on the device itself.
Move the device closer.
Try to exclude first.
Make sure to correctly initiate learn mode on the device itself.
Move the device closer.
Re: Cannot pair anything on new setup
Hi and thanks for the reply. As it happens I decided to order another unit which has installed and paired to several vendors products seamlessly on the same pi/zwave install. Strange but to me that definitely says there is a fault on the original z-wave board.