forum

On 29/03/2013 I updated my Z-Way installation and since then I am getting this in the log

[2013-03-29 xxx] Got frame from device X to controller, but command class 0x20 for device is not registered - instantiating it as not supported

device X is an EZmotion

Is this a bug?

Additionally the sensor data (temperature....) does not get shown anymore in the web interface under menu "Device control" -> "Sensors".

Is this desired?

No, it is not a bug. The device sends up Basic, while it can not accept Basic. So, we create it on the fly as "not supported" by device. This is ok.

As for Sensors, we have updated SensorMultilevel data holder structure to conform Version 5. Please run re-interview (Forcce interview)

The sensors page still just shows the motion part of the EZmotion. The temperature and light is not shown. I can read it with my scripts, but it is not in your webpage. What can I do?

Have you update the s/w (version of 29 March) and re-included (or forced the interview)? Are you useing the UI from the new version of s/w (version of 29 March)?

Automagically and over night, the webpage now shows the desired information. It took some hours....but I have not touched the system meanwhile .... magic ....