Page 1 of 1
Fibaro Door/Window Sensor
Posted: 14 Apr 2013 20:35
by Isaksson
Hello.
I have just included a Door/Window sensor from Fibaro and i have no problem reading the state if its open or closed but i have also added a DS18B20 and my question is if it is possible to view the temperatur from the sensor in the included webgui?
What is the right syntax to grab that value with API?
Thanks
I have a Fibaro sensor multilevel and read it like this...
Posted: 14 Apr 2013 20:35
by krambriw
Isaksson, see below for my device '6' and tempsensor on instance '3'
BestR Walter
http://192.168.10.248:8083/ZWaveAPI/Run ... .val.value
Thanks.
Posted: 14 Apr 2013 20:35
by Isaksson
Thanks.
To bad it did not work for me.
Uncaught TypeError: Cannot read property 'data' of undefined
is it a SensorMultiLevel???
Posted: 14 Apr 2013 20:35
by krambriw
BR
I had to exclude / include
Posted: 14 Apr 2013 20:35
by Isaksson
I had to exclude / include the device after adding the temp sensor. Now I could see both state and temp in the webgui.
Fibaro Door/Window Sensor
Posted: 14 Apr 2013 20:35
by _835_
@Isaksson,
which z-way version you used ?
i do not have success including my fibaro fgk-101, (i got 2) with z-way 1.3.1 and 1.4.1-rc1.
while my aeon 4-1 multi sensor goes fine...
I had to roll back to version
Posted: 14 Apr 2013 20:35
by Isaksson
I had to roll back to version 1.3.1 to get the sensors to work.
Use the "tamper" button on the back to include it, push as fast as you can.