RaZberry not listening?

Discussions about RaZberry - Z-Wave board for Raspberry computer
Post Reply
millmore
Posts: 6
Joined: 17 Aug 2013 17:48

RaZberry not listening?

Post by millmore »

I have a network with 20 or so dimmers and switches, and one fibaro door sensor and an energy monitor. I can happily send commands to every device, but none of the devices seem to send information back to the RaZberry - or the RaZberry is not listening for it. I have a light switch 2m away from the controller, and when I turn it on, the RaZberry never notices that it has been turned on. I have to press Update for it to poll the switch. Similarly, the door sensor never gets triggered - it is noted as last updated shortly after I installed it.

Do I need to do something to make sure it listens to the switches and sensors?

Martin
User avatar
PoltoS
Posts: 7624
Joined: 26 Jan 2011 19:36

Please check that all your

Post by PoltoS »

Please check that all your devices have a group to report state changes (not all devices support this) and that these groups contains RaZberry (i.e. these devices are associated with RaZberry NodeId)
Post Reply