New RaZberry GPIO board installation

[pete]

Great forum here folks!

Yesterday received my new RaZberry GPIO board.

Ran the posted script to update RPi.

The script found the board just fine and appeared to complete with no issues via command line.

Only concern right now is that it seems to be stuck at the upgrading part on the webpage. It has been over 20 minutes here. Should I continue to wait or reboot device?

RPiZBerry.jpg (26.14 KiB) Viewed 2865 times

I rebooted, updated and all is well.

[benv666]

New install here, same problem. After a reboot this went away.

However, the expert interface only gives me errors, no clue what's up with this.
For a new user to Z-Wave the interface is absolutely horrible. How about a "Readme first" or something to explain how this stuff is usally setup?