Razberry->HomeKit: HowTo get Device Support?
Posted: 26 Oct 2015 13:46
Hi,
the z-way server on my raspberry PI with Razberry works very good.
Some connected devices are:
Danfoss Living Connect - DAN_LC-13
Fibaro WallPlug - FIB_FGWPE-101
Fibaro Switch - FIB_FGD-211
Fibaro Roller Shutter - FIB_FGRM-222
Fibaro Multi Sensor - FIB_FGMS-001
Fibaro float Sensor - FIB_FGFS-101
Fakro Windows Motor - FAK_ZWS230
Nearly all of them are working in z-way server.
But if I add HomeKitGate module to z-way server and want to pair the razberry with an iPhone, everytime paring fails.
I´ve started to exclude accessory by accessory.
In previous versions of z-way-server with HomeKitGate I only had to remove the Fakro Motor, and paring works.
From time to time I had to remove even more accessories for successful paring with the iPhone HomeKit, till I only had 2 accessories in my z-way server: Fibaro Roller Shutter and Fibaro WallPlug.
Now, with z-way server 2.1.2-rc5, even this small setup, with those two Fibaro actors, doesn't pair with the HomeKit any more.
So my question: What's going on with accessories,HomeKitGate and HomeKit?
Seems like there are some problems with characteristics from the accessories, so that HomeKit couldn´t pair with razberry.
Is there a way to find out which characteristics causes problems and is it possible to modify those characteristics to make them working?
Razberry z-way server works very well, but HomeKitGate makes it almost useless for me.
Hope someone have some information about that.
thanks and best regards,
dave
the z-way server on my raspberry PI with Razberry works very good.
Some connected devices are:
Danfoss Living Connect - DAN_LC-13
Fibaro WallPlug - FIB_FGWPE-101
Fibaro Switch - FIB_FGD-211
Fibaro Roller Shutter - FIB_FGRM-222
Fibaro Multi Sensor - FIB_FGMS-001
Fibaro float Sensor - FIB_FGFS-101
Fakro Windows Motor - FAK_ZWS230
Nearly all of them are working in z-way server.
But if I add HomeKitGate module to z-way server and want to pair the razberry with an iPhone, everytime paring fails.
I´ve started to exclude accessory by accessory.
In previous versions of z-way-server with HomeKitGate I only had to remove the Fakro Motor, and paring works.
From time to time I had to remove even more accessories for successful paring with the iPhone HomeKit, till I only had 2 accessories in my z-way server: Fibaro Roller Shutter and Fibaro WallPlug.
Now, with z-way server 2.1.2-rc5, even this small setup, with those two Fibaro actors, doesn't pair with the HomeKit any more.
So my question: What's going on with accessories,HomeKitGate and HomeKit?
Seems like there are some problems with characteristics from the accessories, so that HomeKit couldn´t pair with razberry.
Is there a way to find out which characteristics causes problems and is it possible to modify those characteristics to make them working?
Razberry z-way server works very well, but HomeKitGate makes it almost useless for me.
Hope someone have some information about that.
thanks and best regards,
dave