Zipato Keypad Notification Sounds wrong
Posted: 11 Sep 2016 14:33
Referring to the ZIPATO Mini Keypad RFID / Z-Wave I have the following technical problem (not working properly):
Observation:
It seems to me that the notification sounds / acknowledgement sounds that are played do not match to the actual event (N) but correspond the last one (N-1). Can this be fixed?
Details:
I am using ZWAY Razberry on Raspberry Pi as ZWay Center. The Zipato Keypad is connected and I can read the status and configure the device via the HTTP API as well as with the ZWay Web GUI. The ZWave center accepts the set values of the configuration.
Configuration: Comman Class Configuration (0x70):
Parameter 2: value: 1 (feedback time seconds)
Parameter 3: value: 3 (feedback timeout seconds)
Parameter 4: value: 2 (feedback beeps per seconds)
I configured the ZWave Center so it always sends a notification (class 0x25 switch_binary: ON) on each event (new input from keypad).
You can see the problem in this sequence:
0. (past unknown event)
1. Known RFID Tag read -> (depending on past event)
2. Known RFID Tag read -> acceptance sound (two quick beeps)
3. Unknown RFID Tag read -> acceptance sound (two quick beeps)
4. Known RFID Tag read -> error sound (6 fixed beeps)
5. Unknown RFID Tag read -> acceptance sound (two quick beeps)
6. Unknown RFID Tag read -> error sound (6 fixed beeps)
7. Known RFID Tag read -> error sound (6 fixed beeps)
8. Known RFID Tag read -> acceptance sound (two quick beeps)
x. deactivation of notification acceptance message (after that only error sounds should be played)
9. Unknown RFID Tag read -> acceptance sound (two quick beeps)
10. Unknown RFID Tag read -> error sound (6 fixed beeps)
You see that at event (N) the device plays the sound of event (N-1).
How can this be fixed?
Observation:
It seems to me that the notification sounds / acknowledgement sounds that are played do not match to the actual event (N) but correspond the last one (N-1). Can this be fixed?
Details:
I am using ZWAY Razberry on Raspberry Pi as ZWay Center. The Zipato Keypad is connected and I can read the status and configure the device via the HTTP API as well as with the ZWay Web GUI. The ZWave center accepts the set values of the configuration.
Configuration: Comman Class Configuration (0x70):
Parameter 2: value: 1 (feedback time seconds)
Parameter 3: value: 3 (feedback timeout seconds)
Parameter 4: value: 2 (feedback beeps per seconds)
I configured the ZWave Center so it always sends a notification (class 0x25 switch_binary: ON) on each event (new input from keypad).
You can see the problem in this sequence:
0. (past unknown event)
1. Known RFID Tag read -> (depending on past event)
2. Known RFID Tag read -> acceptance sound (two quick beeps)
3. Unknown RFID Tag read -> acceptance sound (two quick beeps)
4. Known RFID Tag read -> error sound (6 fixed beeps)
5. Unknown RFID Tag read -> acceptance sound (two quick beeps)
6. Unknown RFID Tag read -> error sound (6 fixed beeps)
7. Known RFID Tag read -> error sound (6 fixed beeps)
8. Known RFID Tag read -> acceptance sound (two quick beeps)
x. deactivation of notification acceptance message (after that only error sounds should be played)
9. Unknown RFID Tag read -> acceptance sound (two quick beeps)
10. Unknown RFID Tag read -> error sound (6 fixed beeps)
You see that at event (N) the device plays the sound of event (N-1).
How can this be fixed?