ZME Flush Mountable Dimmer Paramter Configuration Problem
Posted: 24 Oct 2012 15:19
Hi, I bought a couple of your Dimmers and Wall Controllers (~20 in summary). Great devices!!! I am using a micasaverde Vera2 as controller...
However, I have a problem with one of them.
All the others list this under capabilities:
211,156,0,4,17,1,L,R,B,RS,|32,38:2,39,112,114,117,119,133,134,135,142,
One of them lists this:
211,156,0,4,17,1,L,R,B,RS,|1,114,117,119,133,134,135,142,
The reason I discovered this is because I wanted paramter 7 set to 1 on all of my dimmers (push up when already on dimms to highest level). This worked fine on all of them except the one. The troublemaker shows 1 as desired value but leaves current value blank. As a result the special gimmick does not work.
I tried reconfiguring it, excluding it from the network and reincluding it... doesn't change.
Could it be that this one has not been flashed correctly with your enhanced firmware?
Should I just return it to the reseller and get a new one?
Kind regards, Andi
However, I have a problem with one of them.
All the others list this under capabilities:
211,156,0,4,17,1,L,R,B,RS,|32,38:2,39,112,114,117,119,133,134,135,142,
One of them lists this:
211,156,0,4,17,1,L,R,B,RS,|1,114,117,119,133,134,135,142,
The reason I discovered this is because I wanted paramter 7 set to 1 on all of my dimmers (push up when already on dimms to highest level). This worked fine on all of them except the one. The troublemaker shows 1 as desired value but leaves current value blank. As a result the special gimmick does not work.
I tried reconfiguring it, excluding it from the network and reincluding it... doesn't change.
Could it be that this one has not been flashed correctly with your enhanced firmware?
Should I just return it to the reseller and get a new one?
Kind regards, Andi