forum

Sorry for resurrecting an old thread, but I recent installed a GD00Z-4 and added it to my ZWay network. I can't seem to get it to register the BarrierOperator command class. I have tried excluding and including, but the interview always seems to get stuck and never shows BarrierOperator as a command class. Based on this thread, it seems I should at least be able to issue http commands, but without BarrierOperater, that would seem impossible. I'm new to the inner workings of ZWay. So I am not too sure where to look for potential errors.

Anyone have any ideas? I've attached some screenshots of what I am seeing. Thanks in advance.

System Info: Interview: Interview Results:

Ok. So I was using my Razberry as a secondary controller and the primary controller seems to the the culprit. I changed the Razberry to the main controller, re-included and now I have all the command classes.