forum

I am using Windows 10.
I have installed Arduino IDE 1.6.5 as described.
When I install Z-Uno 2.0.5 or 2.0.6 then the error "CRC doesn't match..." occurs.
Is there a sollution?

What is your current (installed) version - and what Update URL you are using?

Michael

Hi,

I had the same issue... I just de-installed Arduino and made a new, clean installation (with the update-URL http://z-uno.z-wave.me/files/z-uno/pack ... index.json URL as described here). Then I was able to install 2.0.6 without that error. It seems that as soon as you try to switch between 2.0.5 and 2.0.6 there is miscalculation of the CRC...

Regards,
Andreas.

Hi,

I switched off the virus scanner.
I un installed all and even deleted all data in "C:\Users\Ronald\AppData\".
I followed http://z-uno.z-wave.me/install
Still no success.
I have another error see att

Regards,
Ronald

Hi,

that is strange, in the current error message the path contains "//" which is probably the cause of the error, but I have no idea wheres this would come from...

I can try it on my laptop to verify that it still works on my end, but I can't do it before tommorrow evening.

Regards,
Andreas.

Hi Andreas,

at home I repeated the whole procedure again. Now with the target (zuno) connected.
Now it works.

thanks,
Ronald