Hi,
One of my developers pressed "Reset controller", before reading docs ;-( It caused huge problems because we cannot see devices that were previously included. How could we revert back to "zero state"?
Regards,
Jakub.
Devices not visible after "Reset controller"
Re: Devices not visible after "Reset controller"
Reset Controller is the return to "zero state" Not kidding, really!
If you have made a backup, you can restore this back, but only if your developers pressed that button before resetting
If you have made a backup, you can restore this back, but only if your developers pressed that button before resetting
-
- Posts: 2
- Joined: 11 Apr 2014 12:40
Re: Devices not visible after "Reset controller"
Ok, and what if he didn't make a backup before?
Re: Devices not visible after "Reset controller"
You are unlucky
It is like making "format c:" or "rm -Rf /" without making a backup.
There is still a hope that the xxxxxxxx-DeviceData.xml is still there and this can help to restore all the data, but I assume that if it was a network of your developers, it is easier to just rebuild from scratch (I assume it is a test network)
It is like making "format c:" or "rm -Rf /" without making a backup.
There is still a hope that the xxxxxxxx-DeviceData.xml is still there and this can help to restore all the data, but I assume that if it was a network of your developers, it is easier to just rebuild from scratch (I assume it is a test network)