RAW Info:
----------------------------------------------------------
FIRMWARE DATA
----------------------------------------------------------
(<type 'exceptions.IndexError'>, '<string>', 461)
**** **** **** **** **** *
* * * * * * * * * *
* * * * * * * * * *
**** *** *** * * *** *
* * * * * * * * *
**** * * * * **** * * *
Error 0 Unknown exception "list index out of range"
Error when uploading sketch
Error when uploading sketch
I always get this message when I want to upload a sketch after I already have uploaded one. I have to unplug the Z-UNO in order to upload. I'm on the latest release. Is this a bug?
-
- Posts: 255
- Joined: 26 Jul 2015 17:29
Re: Error when uploading sketch
I have seen something similar, but I cannot remember what caused it. Long shot: do you use debugging via serial over usb? I have been using debugging over seria uartl instead of usb for the last few months, and I think that might have solved it.
Meet me here: https://forum.fibaro.com/index.php?/pro ... rgebruers/ or here: memberlist.php?mode=viewprofile&u=564463
Re: Error when uploading sketch
Select the correct port.
Re: Error when uploading sketch
The port should be correct because it works the first time and after reconnecting. However I will check next time to be sure.
I'm not using debugging functions, but thanks for the hint.
I'm not using debugging functions, but thanks for the hint.
Re: Error when uploading sketch
I confirm the port is correct. I uploaded the sketch once and after it close the port I uploaded it again >> Error.
Now it doesn't work until I unplug it once.
Now it doesn't work until I unplug it once.