I'm using Z-Wave.Me UZB as a bridge controller for Z/IP Gateway. It works fine until I start to communicate with devices. Every time when I send commands I get the next errors in zipgateway.log.
Code: Select all
SerialAPI: Command: 0xa5 is not supported by this SerialAPI
SerialAPI: Assertion failed at /var/lib/jenkins/jobs/Full_S2_Gateway_release/workspace/src/serialapi/Serialapi.c:600
SerialAPI: SendFrameWithResponse() returning failure
33324 virtual_nodeid_init_count: 0
33341 Creating virtual node
SerialAPI: Command: 0xa4 is not supported by this SerialAPI
SerialAPI: Assertion failed at /var/lib/jenkins/jobs/Full_S2_Gateway_release/workspace/src/serialapi/Serialapi.c:600
SerialAPI: SendFrameWithResponse() returning failure
33341 create failed, will retry
34341 Creating virtual node
SerialAPI: Command: 0xa4 is not supported by this SerialAPI
SerialAPI: Assertion failed at /var/lib/jenkins/jobs/Full_S2_Gateway_release/workspace/src/serialapi/Serialapi.c:600
SerialAPI: SendFrameWithResponse() returning failure
34341 create failed, will retry
This problem is also described on Z-Wave Public Forum.
Thank you