Hello,
I habe an UZB1 with newest firmware that makes Problems in including new devices.
On fhem and openhab I get instantly the error that the transmit queue is full.
Contacted both developer and both stated a messed up Stick.
Tried to downgrade firmware and reupgrade but both results in the same behaviour.
Is this a know Problem and is there any fix without hard reset and learn 80+ devices new.
Regards
Robert
UZB1 TransmitQueue overflow
Re: UZB1 TransmitQueue overflow
We do not know about such a problem. You might want to make a backup and restore it back after full reset