Where to get the firmware

[PoltoS]

What is your current issue? The firmware looks ok

[herbert-f]

I can't access and no Nodes available ...

Code: Select all

Role in Network
Node Id:	
Home Id:	
Primary Role:	No
Primary Capability:	No
SUC/SIS in network:	
Hardware
Vendor:	
Vendors Product ID:	/
Z-Wave Chip:	
Firmware
Library Type:	
SDK Version:	
Serial API Version:	
Capabillities:
UUID:	
Subvendor:	
Nodes limit:	
Controller Static API	
Allow max RF power	
Backup/Restore	
Battery save on sleeping	
Advanced network diagnostics	
Z-Wave Long Range	
Fast communications	
Change vendor ID	
Promiscuous mode (Zniffer)	
Full Zniffer	
RF jamming detection	
Capabillities:	
Software Information
Version number:	
Compile-ID:	
Compile-Date:	
UI
UI version	v1.5.9
Built date	02-04-2022 00:10:16

[lanbrown]

Z-Way doesn't see the Razberry 7 board; hence why the fields are blank. Have you tried shutting down the Raspberry Pi, unplugging it for 10 seconds and plugging it back in to perform a hard reset?

[herbert-f]

Yes. also more than 300 seconds

[PoltoS]

Please show the log. What have you done last? Were you able to check the firmware version after the last upgrade?

[herbert-f]

Hi Polto,

I bought yesterday a new Razberry 7 Pro - it works.

To repair my defect Razberry - I think - I must flash correct bin files for the bootloader and the firmware. The glb-File show this error:

Error 0 Hex file contains invalid record at line 1 while loading the bootloader
file:Razberry07.17.01.02.glb

Please send me bin-Files for the bootloader and the firmware - I try to flash with:

Code: Select all

./ZMESerialUpdater serialapi_uzbupdate -b bootloader.bin -f firmware.bin -d /dev/ttyAMA0

Thanks

[PoltoS]

Please don't do that, but use Z-Way UI to get updates instead.

Go in Expert UI > Network > Controller Info > Firmware Upgrade

[herbert-f]

This is not impossible - the board was not found !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

[herbert-f]

I can't access and no Nodes available ...

Code: Select all

Role in Network
Node Id:	
Home Id:	
Primary Role:	No
Primary Capability:	No
SUC/SIS in network:	
Hardware
Vendor:	
Vendors Product ID:	/
Z-Wave Chip:	
Firmware
Library Type:	
SDK Version:	
Serial API Version:	
Capabillities:
UUID:	
Subvendor:	
Nodes limit:	
Controller Static API	
Allow max RF power	
Backup/Restore	
Battery save on sleeping	
Advanced network diagnostics	
Z-Wave Long Range	
Fast communications	
Change vendor ID	
Promiscuous mode (Zniffer)	
Full Zniffer	
RF jamming detection	
Capabillities:	
Software Information
Version number:	
Compile-ID:	
Compile-Date:	
UI
UI version	v1.5.9
Built date	02-04-2022 00:10:16

[PoltoS]

So, ./ZMESerialUpdater serialapi_uzbupdate -d /dev/ttyAMA0 does not see the board neither after the upgrade?