Hello,
How can i have the state of the move sensor ?
http://192.168.1.34:8083/ZWaveAPI/Run/d ... .val.value doesn't work
Thanks
Aeotec multisensor
Depends on the device.
Depends on the device.
Usually http://192.168.1.34:8083/ZWaveAPI/Run/d ... evel.value reports it (since it is a binary sensor, not multilvel).
Note, that due to change in Z-Wave Command Classes specification in next version this will become:
http://192.168.1.34:8083/ZWaveAPI/Run/d ... evel.value
Usually http://192.168.1.34:8083/ZWaveAPI/Run/d ... evel.value reports it (since it is a binary sensor, not multilvel).
Note, that due to change in Z-Wave Command Classes specification in next version this will become:
http://192.168.1.34:8083/ZWaveAPI/Run/d ... evel.value