Hello,
I'm new to Razberry. I recently purchased an Enerwave Scene Controller and a light switch to go with it. I'd like to set up the controller to turn on the switch when one of the 7 buttons is activated. I cannot figure out how to do this using the expert UI.
Thus far, I've tried adding the switch to association group(s) in the controller configuration, and vice-versa. So far, all I see is adding a device, with no additional options for configuration (see: http://imgur.com/MaJlyuF )
I feel like I'm missing some step here after a device is added to the group, but can't figure out what it is!