TimeParameter command class don't show up in ExpertUI

[KGBEl]

Hi, earlier I have been able to update the internal clock in my Z-Uno (ver 2), via TimeParameter command class.

For som unknown reason I changed frequence to RU and lost contact with Z-Uno.
So I removed it via "Failed node" before I noticed the frequence fault.

Then I excluded Z-Uno it from network and included it again.
Now in expert UI there is no TimeParameter command class showing.

It's 3.0.12 running.

What have I done wrong?

[PoltoS]

Sure it us not in rescue mode? Is your sketch still running?

[KGBEl]

Yes it is running.

How do I know if it's in rescue mode?

[KGBEl]

If rescue mode changes to normal state after reset, it is in normal state.

[KGBEl]

Hi again.

I have excluded and included again, no difference, still no TimeParameter command class.

What is wrong?