Reset Devices

[dario87]

hi,
I have a problem when I reset the devices.
When I reset the devices can no longer control them with z-way.
I have to enter the interface expert and i must do "(Re-) includes device".
How can I fix the problem?

thanks

[PoltoS]

Reset is supposed to clear device and clear any information about the network it was in. So, you will not be able to control it after resetting.

[dario87]

So if I replace the battery in a device, must I to do "(Re-) includes device"?

[pofs]

So if I replace the battery in a device, must I to do "(Re-) includes device"?

No, device should normally wakeup and continue functioning after battery replacement.
How it is related with resetting a device?

[dario87]

hi
thanks for replies.
I have one "Aeon micro smart switch (2nd edition)" and one "Aeon MultiSensor" device.
When i have a blackout, after I can no longer communicate with the "Aeon micro smart switch (2nd edition)". I have to do "Remove failed node" and after "(Re-)include device".
Removing the battery to "Aeon MultiSensor" device, i have the same problem.
If I put the new battery, I have to do "Remove failed node" and after "(Re-)include device".
I hope I was clear

thanks