Fibaro FSS-001

[pierre2302]

hello

I installed the smoke detector FSS 001,the temperature is displayed but nothing against the smoke . How to have the state feedback ?

thank you

[PoltoS]

This device uses Alarm CC. We are working to make it work in latest versions.

[pierre2302]

thank you poltoS, hoping you'll get there soon

[Mirar]

Any news from this?

Neither smoke alarm nor temper alarm outputs anything in any way.

The FSS-001 also have a "black box recording" which I'm not sure what it is and how it's supposed to work, starting to log smoke levels before the alarm is triggered.

[Mirar]

Actually I get alarm readings fine, although I have only tested the tamper alarm "General Purpose Alarm". Heat and Smoke alarms show up as well.

I'm not sure if I see any smoke readings. Will do a smoke test at some point later.

[PoltoS]

Just added AlarmSensor in v2.0.1-rc2

[Mirar]

I saw, great. (I'm actually mainly using the JSON interface, and that worked since v2.0.0. I also wrote a backend to SMS me on these events.)

I still don't know how the "smoke level" logging is supposed to work, but I'll try with some smoky burning newspaper some other day.


edit: Where can I see "AlarmSensor" in the interface? I can't find it anywhere in rc7 (which I presume will have that as well), neither /expert nor /blueui. It might be in the home automation, but I haven't learned how to navigate that.

[pierre2302]

- Sensors (Generale purpose alarm / Smoke / Heat) ghost appearing with the expert interface. Against only by the temperature with blueui

- Too bad there is still no sensor (idle / triggered) that informs the detector status

Z way version 2.0.1-RC12

[pierre2302]

The same problem as the KFOB Zwave me always no return of state JSON.

I hope that the update will soon arrive, her this kept waiting!

At present unusable with openremote!!