probably it is too late but I can not interview my fibaro wall plug on my raspberry pi 1 and z-wave bord. My fibaro motion sensor was unproblematic. I could include the wall plug directly after 3 times pressing the b-button ( the automatic procedure didn't work), but under configuration the wireless activitity shows - "Device seems to be dead". A force interviewe is working for the command class BASIC and CONFIGURATION. Maybe I need a step by step instruction. Thanks in advance for your feedback.
I remember I had to bring my 2 devices pretty close ( a few meters) to the RaZberry to get it included. The device could be defective, which is not "uncommon" for Zwave devices if I read these forums. That being said, problems are more often communicated than successes
probably you are right. I have sent the adapter back. By the way, I tested openhab on my Raspberry P1 and let me say it makes much more fun with a P2 in terms of let me say stability.
. Yes, I first exclude the wall plug before I included the adapter. I reset the adapter as well.