Can't include Fibaro dimmer

[muddymickey]

Hi all

First post here,and first adventure with Z-wave, as I try to replace some old X10 gear.

I have a Raspberry Pi running Domoticz, and have just bought a Razberry board.
I've set this up and added it as a device in Domoticz, looks OK as far as I can tell.

I have one Z-wave device that I am trying to include, a Fibaro FGD-212 dimmer (EU version).

In Domoticz, I try to include the node, and I set the FGD-212 up for inclusion, eitherby pressing my (retractable) wall switch quickly 3 times, or the "B" button quickly 3 times.

The LED lights red on the Razberry board - but then nothing happens. The dialog in Domoticz stays open, waiting for the device to include, but this never happens - the only option is to abort. When I do abort, the red LED on the Razberry goes off.

Any ideas what might be the issue ?

When I press the B button 3 times quickly on the Fibaro, should the LED on the Fibaro dimmer light up ? (It doesn't - just don't know if it should or not)
How can I be sure I've got the EU version of the Razberry ? The crystal seems to be marked "U" but I'm not sure what that indicates.

Thanks for any suggestions. Hopefully it's just me doing something daft...

[pz1]

Since you are not running ZWay, you better ask the guys on Domoticz forum

[muddymickey]

Thanks, I have done.

Any ideas how I can confirm if I've got the EU or US version of Razberry board though?

[pz1]

Any ideas how I can confirm if I've got the EU or US version of Razberry board though?

In the ZWay software you could see it via Expert User Interface menu /network/Controller Info

[muddymickey]

Does anyone know if the letter "U" on the crystal indicates EU or US frequency?