Hi,
I´m a beginner to this great system and I like it a lot.
But it´s hard to get some of these settings.
I have a Rpi with v2.3.7-rc2 ZwaveMe on it, and a Razberry for my devices.
I have installed 6 Sensative stripes in the doors in my house and they are working.
Now I want to get notifications when a door opens.
I have tried Pushover App and it worked, but it´s slow and I get a lot of notifications I don´t want.
And somehow if I deselect all the four check-boxes at the top it gives me nothing from Pushover.
Regardless if I have configured it below for each sensor.
So I installed Push-Me App, but I have hard to understand the right way of configure it.
Together with Push-Me I have installed If/Then App to get it to work.
Now I get a notification but not which sensor it is. Just the text that is typed in Push-Me.
Do I have to make a "clone" of the Push-Me app to every sensor, and name it to different names like each sensor to get the right info pushed to my cellphone?
I´m confused!
Is there no HOWTO for this?
I have searched the forum but no luck.
Thanx for a great forum
/Juppe
Pushover/Push-me howto?
Re: Pushover/Push-me howto?
I solved it!
Had to clone the "Push-Me" App for each sensor and for "opened" + "closed" and then clone "If/Then" and name them "open" + "closed" to each sensor.
Now it works. A lot of "cut´n paste"
Phuuu!! =)
Had to clone the "Push-Me" App for each sensor and for "opened" + "closed" and then clone "If/Then" and name them "open" + "closed" to each sensor.
Now it works. A lot of "cut´n paste"
Phuuu!! =)