Hallo,
I have the exact same problem, but I can´t solve it.
Vendor: RaZberry by Z-Wave.Me
Vendors Product ID: 1024 / 1
Z-Wave Chip: ZW0500
I've installed the razberry image to a Pi 2 Model B+ and updated everything via
apt update
apt full-upgrade
I went to:
http://192.168.0.93:8083/expert/#/uzb
and see these entries:
Code: Select all
2015-01-01 5.0 Update bootloader from default for 5.00 to 538d
2015-09-15 5.0 5.4 Update firmware from 5.00 to 5.04
2015-09-18 5.0 5.3 Update firmware from 5.00 to 5.03
and if I use the "Upgrade bootloader" button it communicates with the device (a few seconds later the green and the red led flash up for a second) but when I go to the page again I still see the same entries.
Another thing:
Code: Select all
./ZMESerialUpdater serialapi_uzbupdate -d /dev/ttyAMA0
I try to run the updater from the web browser from zwave and also tried the ZMESerialUpdater serialapi.... direct from the raspi desktop.
After nearly 15 min. occurs an error massage Error 0 (don´t remember exact) unexpected direction programmer.
In general the LED of the Razberry control modul are permanently on (1red & 1 green).
Please, I need help in this case!