Discussion about Z-Uno product. Visit for more details.
Posts: 8
Joined: 21 Jul 2020 23:47

Re: Fritzing

Post by jalvarezprz »

I don't know if I explained myself well, what I meant is that the ZUNO, at this moment, can only be seen and used in Fritzing's "breadboard" mode. My proposal is that it can also be viewed in "schematic" and "pcb" modes.
In my opinion, this would facilitate the work of the ZUNO community, to make more solid developments with ZUNO, especially with regard to designing the printed circuit boards.

User avatar
Posts: 5973
Joined: 26 Jan 2011 19:36

Re: Fritzing

Post by PoltoS »

Sure, I understood you right. When we did Fritzing, we expected many people to use it, but actually thare are not that many.

We did it more to draw beautiful examples on our site ;) But anybody can extend our Fritzing file to add the schematic and pcb sections too.

Post Reply