I can switch the sirene on and off. But with the toggle button which i make with the Code device " zway.SendData(66,[113,5,0,0,0,0,6,22,0,0]) " i dont get any output.
Sorry, no other idea. The command is delivered from your expert menu message, so the siren is not responding.
Maybe you should factory reset it and reinclude again for another test.
Oh, one more idea. Did you check in configuration tab that the 4 is set to 0?
Nº 7 - Customer Function
(0) ---
(1) ---
(2) ---
(3) ---
(4) Notification Type, 0: Using Notification Report. 1: Using Sensor Binary Report.
(5) ---
(6) ---
(7) ---
Updated: 2018-01-12 | Set value: 0 | Default value is: 0