Can you give us your"some response in the expert menu"? This may help
And, is your siren responding if you switch it on manually in the menu?
Send Notification_report to play chime
Re: Send Notification_report to play chime
Hello enbemokel, thx for the reply and sorry for the delay. This Info i get from the expert Job Queue
1 D + + + 13.80 66 Alarm Delivered 42 a 71 5 0 0 0 0 6 16 0 0 25
I can switch the sirene on and off. But with the toggle button which i make with the Code device " zway.SendData(66,[113,5,0,0,0,0,6,22,0,0]) " i dont get any output.
1 D + + + 13.80 66 Alarm Delivered 42 a 71 5 0 0 0 0 6 16 0 0 25
I can switch the sirene on and off. But with the toggle button which i make with the Code device " zway.SendData(66,[113,5,0,0,0,0,6,22,0,0]) " i dont get any output.
Re: Send Notification_report to play chime
Hi eyeq202,
just one note. If your siren communicates thru Security CC
use zway.SendDataSecure instead of zway.SendData
Bjoern
just one note. If your siren communicates thru Security CC
use zway.SendDataSecure instead of zway.SendData
Bjoern
Re: Send Notification_report to play chime
Hmm, your expert Job Queue is looking good for me, maybe Bjoerns answer is helpful.
Re: Send Notification_report to play chime
thx for the reply guys.
@Bjoern : i try your suggestion but without any luck.
Is there any other chance to get this thing working proper ?
@Bjoern : i try your suggestion but without any luck.
Is there any other chance to get this thing working proper ?
Re: Send Notification_report to play chime
Sorry, no other idea. The command is delivered from your expert menu message, so the siren is not responding.
Maybe you should factory reset it and reinclude again for another test.
Maybe you should factory reset it and reinclude again for another test.
Re: Send Notification_report to play chime
Oh, one more idea. Did you check in configuration tab that the 4 is set to 0?
Nº 7 - Customer Function
(0) ---
(1) ---
(2) ---
(3) ---
(4) Notification Type, 0: Using Notification Report. 1: Using Sensor Binary Report.
(5) ---
(6) ---
(7) ---
Updated: 2018-01-12 | Set value: 0 | Default value is: 0
Nº 7 - Customer Function
(0) ---
(1) ---
(2) ---
(3) ---
(4) Notification Type, 0: Using Notification Report. 1: Using Sensor Binary Report.
(5) ---
(6) ---
(7) ---
Updated: 2018-01-12 | Set value: 0 | Default value is: 0
Re: Send Notification_report to play chime
Hi enbemokel, which configuration tab you mean ? Can you explain ?
thx
thx
Re: Send Notification_report to play chime
Its WORKING !!!!! Thx guys. The info from enbemokel was great. Thx sooo much.
Re: Send Notification_report to play chime
Thanks for information that it works