RaZ board dead

[DesT]

@PoltoS,

I think my RaZ board is dead.. when the raspberry boot the RaZ board LED is red and I can't use it!

Is there a way that I can use my spare board (for sure I'm not having a backup) without having to reinclude all the devices?

[DesT]

@PoltoS,

I finally managed to saved a lot of works by still having my old UZB paired to this network with an old backup!
Anyway, I managed to re-pair all the latest devices that I installed...

BUT, I'm having a couple of "dead" devices that I try to "delete" and they always come back and I'm having an error when deleting them.

Also, is the a way to do local backup of the config every day ?

[DesT]

2021-02-07 15_09_55-Z-Wave Smart Home — Firefox Developer Edition.png (25.28 KiB) Viewed 4927 times

[PoltoS]

Delete failed nodes from Expert UI

You can do local backup using curl - the request for backup is simple via API call.

[DesT]

@PoltoS,

Deleting from expert UI did nothing!

The device disappear from the list but come back again!

[DesT]

Here's something in the log while deleting

[PoltoS]

This means the chip was able to contact that device and marked it as alive back

[DesT]

@PoltoS,

I did the entire house, room by room to took the z-wave inventory, also made an excel document

And I have no idea where these device can be... I even check my invetory before the crash and those device ID was not used...

Is it possible that a device answer to 2 different ID ?

[PoltoS]

No, it is not possible. Though,... everything is possible in IT

Try to press Ping button on Status page and then remove again